Please, please help me!! I don't know how to do this?!

[zzaz3]

I just made a VGA breakout cable and now I have no idea how to output onto the arcade monitor.  I've tried soft-15khz, but I can't tell if it's actually working or not?  All I see when I connect it into the monitor is a wave-y green screen.

In fact, I'm not ever sure if my monitor is 15khz.  It's a Sanyo 20-EZV from a Nintendo cabinet.  I've already set it up to run without inverting the colors.  I just need to configure my computer to output everything to that monitor.

I don't have arcadeVGA and I'm probably not going to buy it anytime soon.  I've read that it's possible without it.  But I'm not sure.

Any help would be greatly appreciated!!!!  Thank you!

[Ginsu Victim]

In fact, I'm not ever sure if my monitor is 15khz.  It's a Sanyo 20-EZV from a Nintendo cabinet. 

It is 15KHz

[discgolfer72]

you need to set your resoultion to under 640x480 and  at the lowest refresh rate possible
then adjust the sync on the monitor using the pots on the chassis board
here is a pic of the ez 20 controll sheet




ps where are you located id trade you a nice wg monitor for that ez as i need one bad for my dk im restoreing  id hate to see a good ez used in mame when wg monitors are a dine a dozzen

[zzaz3]

I'm in Georgia, near Atlanta. 

I guess I'd be willing to trade.  What size is your monitor and how old is it?

[discgolfer72]

damn way to far to make a trade lol im in ks

i have a 19 inch ey-ego and a wg 19 inch dont rember the model but it has the remote adj board so its made after 1995



let me know if you need any more help getting that ez to sync up

[zzaz3]

actually, the computer I was using for this cab wont boot now for some reason.  Just my luck.  I thought I was so close...  Guess I'll just have to wait a little bit longer to set it up. 

Thanks for the help though!  Should come in handy by the time I get this sucker fixed.