Arcade Collecting > Pinball

Loose Flipper

<< < (2/3) > >>

ChadTower:

Then back up and tell us what it did come with.  A full rebuild usually includes that part in order to replace the linkage on it.

shredso:
Complete Kit Includes:

2 Plungers & Links Assy
2 Spring Washers
2 Return Springs
2 Coil Stops
1 Lever Arm Assy-R
1 Lever Arm Assy-L
1 EOS Switch & Cap-R
1 EOS Switch & Cap-L
2 Flipper Bearings
2 Sleeves
6 Screws
6 Split Washers
2 Retaining Rings


Part#
KT-GFLIP05
$64.12

Wont have a chance to disassemble until later, too bad, I wanted to try and order parts today.

ChadTower:
That has the shaft in it.  I'm talking about the part that gets pulled into the coil.  Not that part that is attached to the plastic flipper.



EDIT:  plunger... that's what I'm talking about.  I always see that as the shaft because I don't really visualize the flipper itself as part of the mech even though it is.

shredso:
The rebuild kit didn't come with part 26497 flipper shaft assembly, it would make sense that has some wear, hopefully I can get this apart soon and verify so I can order my parts and beat this damn game!!

shardian:
Mine came loose a time or two after I reassembled my playfield. I just cranked down hard on the set screws so they dug in. It hasn't come loose since.

Navigation

[0] Message Index

[#] Next page

[*] Previous page