Main > Main Forum
control pannel/winpac issue - please show me your mame wisdom
<< < (3/3)
omnivorism:

--- Quote from: st on August 08, 2009, 05:46:44 pm ---
--- Quote from: omnivorism on August 08, 2009, 01:44:00 pm --- I know you can change the controls in those, but the default key config on the IPac is kinda wacky.

--- End quote ---

If the jumper is set to MAME, then the IPAC will be using the MAME defaults. So, it should behave with an untouched install of MAME.

--- End quote ---

I had already changed the defaults on every emulator I have so they were more universal.   
omnivorism:
Strange.

I tried again, and as far as i know the only thing i did differently was highlight "debug mode" and it says "programed sucessfully".  The only bad side to this, is that i changed all the player 2 keys to none for now. so i will have to program it again.

omnivorism:

--- Quote from: omnivorism on August 08, 2009, 07:00:03 pm ---Strange.

I tried again, and as far as i know the only thing i did differently was highlight "debug mode" and it says "programed sucessfully".  The only bad side to this, is that i changed all the player 2 keys to none for now. so i will have to program it again.



--- End quote ---

reprogrammed with player 2 also in mind.

I'll just have to go through and make sure my wiring is all good and see how well it works now.
Navigation
Message Index
Previous page

Go to full version