| Main > Main Forum |
| Table saw: This one good enough for wood/MDF control panel work? |
| << < (5/5) |
| miles2912:
A cheap circular saw and this thread are your friend. http://forum.arcadecontrols.com/index.php?topic=43568.0 A table saw is overkill and not needed. I used a cheap folding table and some clamps to do most of my cutting. |
| GaryMcT:
Awesome. . thanks. Bookmarked! :) |
| ChadTower:
I agree fully that the tablesaw is an unnecessary luxury here but don't go too cheap on that circular saw. Anything less than a Black and Decker is probably more dangerous than it's worth. |
| GaryMcT:
Thanks for the info. I'm going to try to stick with a jigsaw for rough cuts and the router for final stuff along with a clamped straight edge and some antislip material. I don't have a circular saw yet, so I'm going to try to avoid it for now. |
| orion:
I own that particular table saw. As mentioned before you can't really cut large pieces on it with out cutting them down first. I would have to say that for the money, it's pretty decent. |
| Navigation |
| Message Index |
| Previous page |