Main > Main Forum

Need some info on shorter length buttons

Pages: << < (2/3) > >>

garnerb350:


--- Quote from: dirkomatic on July 17, 2009, 03:06:24 pm ---For some reason my X-Arcade buttons are shorter than the Happ buttons.  Not sure if you can buy the start buttons separately, but if you need just a little bit, I would think they just might work.  I can measure them sometime this weekend...

--- End quote ---

Doc I forgot all about that....( i have an x-arcade)...

...those Yenox look shorter...but you might can do better (price wise) with the x-arcade....( i dont know, i cant see the X-arcade site from here at work)

dirkomatic:

I don't see where you can buy the X-Arcade buttons individually on their site.  I may have an extra set.  I'll see when I get home.  If I do, you can have them.

garnerb350:


--- Quote from: dirkomatic on July 17, 2009, 03:29:42 pm ---I don't see where you can buy the X-Arcade buttons individually on their site.  I may have an extra set.  I'll see when I get home.  If I do, you can have them.

--- End quote ---


Rock on!

Dr Zero:


--- Quote from: bkenobi on July 17, 2009, 02:42:05 pm ---Aren't the Sanwa buttons for metal CP's?  I suppose if you routed out some area around the buttons on the bottom of the CP, you might be able to make them fit though.

--- End quote ---

It is a metal CP, guess I should have mentioned that part  :-\

Dr Zero:


--- Quote from: dirkomatic on July 17, 2009, 03:29:42 pm ---I don't see where you can buy the X-Arcade buttons individually on their site.  I may have an extra set.  I'll see when I get home.  If I do, you can have them.

--- End quote ---

Hey thanks for that! if you have some spares that would great, thanks!

When I get a selection of buttons I plan to cut some aluminum I have and do a side shot with all installed side by side so folks can have a reference down the road.


Pages: << < (2/3) > >>

Go to full version