| Main > Main Forum |
| Need some info on shorter length buttons |
| << < (2/3) > >> |
| garnerb350:
--- Quote from: dirkomatic on July 17, 2009, 03:06:24 pm ---For some reason my X-Arcade buttons are shorter than the Happ buttons. Not sure if you can buy the start buttons separately, but if you need just a little bit, I would think they just might work. I can measure them sometime this weekend... --- End quote --- Doc I forgot all about that....( i have an x-arcade)... ...those Yenox look shorter...but you might can do better (price wise) with the x-arcade....( i dont know, i cant see the X-arcade site from here at work) |
| dirkomatic:
I don't see where you can buy the X-Arcade buttons individually on their site. I may have an extra set. I'll see when I get home. If I do, you can have them. |
| garnerb350:
--- Quote from: dirkomatic on July 17, 2009, 03:29:42 pm ---I don't see where you can buy the X-Arcade buttons individually on their site. I may have an extra set. I'll see when I get home. If I do, you can have them. --- End quote --- Rock on! |
| Dr Zero:
--- Quote from: bkenobi on July 17, 2009, 02:42:05 pm ---Aren't the Sanwa buttons for metal CP's? I suppose if you routed out some area around the buttons on the bottom of the CP, you might be able to make them fit though. --- End quote --- It is a metal CP, guess I should have mentioned that part :-\ |
| Dr Zero:
--- Quote from: dirkomatic on July 17, 2009, 03:29:42 pm ---I don't see where you can buy the X-Arcade buttons individually on their site. I may have an extra set. I'll see when I get home. If I do, you can have them. --- End quote --- Hey thanks for that! if you have some spares that would great, thanks! When I get a selection of buttons I plan to cut some aluminum I have and do a side shot with all installed side by side so folks can have a reference down the road. |
| Navigation |
| Message Index |
| Next page |
| Previous page |