| Main > Main Forum |
| GaryMcT's 2-player generic control panel layout |
| << < (46/70) > >> |
| GaryMcT:
I picked up a 3/4" long 5/16" diameter pattern bit today to route the joystick cavities. I'll make a template for that when I get home. Do you route the joystick cavity first and then drill the hole for the handle or vice versatile? Any advantage to going either way? |
| GaryMcT:
What's the best way to make the template for the joystick routing? Router and clamped straight edge for each side? I just failed miserably at making one out of plywood. I think it's MDF for me from here on out. :) |
| Bender:
I made a jig for cutting squares and rectangle templates it looks like this just 4 strips of wood you just slide them to the desired shape and size then you can either screw, glue, doublesided tape, or clamp them down I like doing the hole after to make sure it's centered I take the metal plate off the joystick and use to trace and after the area is routed out, I screw it in THEN mark the center and drill it |
| GaryMcT:
--- Quote from: Bender on August 08, 2009, 11:05:51 pm ---I made a jig for cutting squares and rectangle templates it looks like this just 4 strips of wood you just slide them to the desired shape and size then you can either screw, glue, doublesided tape, or clamp them down I like doing the hole after to make sure it's centered I take the metal plate off the joystick and use to trace and after the area is routed out, I screw it in THEN mark the center and drill it --- End quote --- Hey that's a nice jig! I finished making the joystick template out of 1/2" plywood a bit ago. I marked the rectangle and used an angle clamped down once for each corner and template routed the template. Certainly good enough for something on the backside of the panel. I made the template such that the distance from one of the edges is the same as on the control panel to help with lining it up. Next thing I did was to completely screw up the MDF prototype I was working on! I don't know what I was thinking, but instead of just routing to the correct depth for the joystick, I decided to drill some starter holes all the way through. . ummmm, FAIL!!!!!! I'll start over again tomorrow. With all the templates and such building up, I'm getting faster at this at least. :) |
| GaryMcT:
Looks like I can actually finish the one that I'm working on and have it be ugly where one of the joysticks is at. That'll give me some more practice at least. :) |
| Navigation |
| Message Index |
| Next page |
| Previous page |