Main > Main Forum
Trimming adhesive vinyl
Pages: (1/1)
bungy:
Does anyone have experience trimming adhesive vinyl once it has been applied to the side of a cabinet? I am using HAPP's black pica vinyl. I did a few tests trimming with a bare razor blade - it works well on the straight edges, but the inner and outer rounded corners are a bit of a problem.
Maybe it would look good to leave 1/8" to 1/4" hang over the edge and fold it under the t-molding. Has anyone tried this?
Malenko:
--- Quote from: bungy on July 01, 2009, 01:25:59 pm ---Maybe it would look good to leave 1/8" to 1/4" hang over the edge and fold it under the t-molding. Has anyone tried this?
--- End quote ---
I use an exacto knife and leave a little overhand to go under the tmolding
Ginsu Victim:
--- Quote from: Malenko on July 01, 2009, 01:49:35 pm ---
--- Quote from: bungy on July 01, 2009, 01:25:59 pm ---Maybe it would look good to leave 1/8" to 1/4" hang over the edge and fold it under the t-molding. Has anyone tried this?
--- End quote ---
I use an exacto knife and leave a little overhand to go under the tmolding
--- End quote ---
This.
Pages: (1/1)