| Main > Main Forum |
| Construct removable panel |
| (1/1) |
| Fitznab:
Hello All, I am building the Ultimate Arcade II. I notice that once its put together and laminated there is no way to get to the inside, the screws are covered up. Also I assume after a while the screw holes would wear out. So what recommendations do you all have on making either the front panel or the back panel removable. * I thought about just putting in some magnets to hold it in place, but the panel is just too heavy. * I could put hinges on one side, just have to figure out a way to hide the latch on the opposite end. |
| Dazz:
The rear panel is easy to make removable... I have my rear panel setup with a cam lock. |
| Navigation |
| Message Index |