Main > Main Forum

Radius and T Molding

Pages: << < (2/2)

RayB:


--- Quote from: NoOne=NBA= on June 28, 2009, 05:03:31 am ---The big problem is going the other way.
With an inside radius, there's nothing to hold the t-molding in.
That's where finishing nails come in.
A few carefully placed nails through the side of the cabinet, and into the t-molding work perfectly.

--- End quote ---
No no no... cut pie wedge shapes. Or even rectangle protrusions are good enough to hold it. Don't cut it all off on inside curves.

Pages: << < (2/2)

Go to full version