Main > Main Forum
Radius and T Molding
<< < (2/2)
RayB:

--- Quote from: NoOne=NBA= on June 28, 2009, 05:03:31 am ---The big problem is going the other way.
With an inside radius, there's nothing to hold the t-molding in.
That's where finishing nails come in.
A few carefully placed nails through the side of the cabinet, and into the t-molding work perfectly.

--- End quote ---
No no no... cut pie wedge shapes. Or even rectangle protrusions are good enough to hold it. Don't cut it all off on inside curves.
Navigation
Message Index
Previous page

Go to full version