Arcade Collecting > Restorations & repair
GORF!!!!
dmel75:
Yeah, it's definitely got one leg, (the one at the top of the resistor in that picture) that's not connected. Is this something I can replace or do I need to get a new monitor chassis/card set?
SirPeale:
I don't know if YOU can replace it (you haven't specified your soldering skills) but it most certainly can be replaced!
Of course afterward you'll have to figure out what happened to it. Very strange for a LEG to burn up, usually the whole thing cooks.
dmel75:
I can solder fairly well enough do get this done. Just need to figure out the actual part no. and try and order it's modern day equivalent. I can't quite read anything other than 100ohm and 5%5W.
SirPeale:
--- Quote from: dmel75 on June 10, 2009, 01:42:33 pm ---I can't quite read anything other than 100ohm and 5%5W.
--- End quote ---
That's all the info you need. It's a 100 ohm resistor @ 5 Watts.
Expensive to ship JUST that resistor, unless you can find someone that'll drop it in a padded envelope @ standard 1st class rates. Or wait until you find other stuff that needs to be ordered.
SirPeale:
Here. I think.
http://mouser.com/Search/Refine.aspx?N=4141081+4294576007+4294648889+4294741869
Guessing as to the resistor type.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version