Main > Main Forum
Ultrastik 360 problem outputting to IPAC
Pages: (1/1)
genesim:
I cannot figure this out!!
I have to Ultra360's and they are both recognized fine through the USB. The problem is that I need it to output to a key pad.
I have it going through a USB in the PCI slot. 2.0 Works fine. Regular USB nonPCI works fine.
But here is the problem. The wiring harness....nothing. So I tried testing each individual post. The only one that works is a wire coming from the Ipac regular key command to the ground. That lights up the key???
Yet nothing else works.
Not any other combination. Only a key command to ground. Why would this be? Shouldn't it be key command to key command ground to ground? Is there a setting that makes the Ultra360 to output mode?
genesim:
Let me ask it another way.
Ok if I want the 4 way output to Ipac do I hook up Ground or 5 Volt if I have the stick going through USB?
So far nothing is working. Green/Yellow/Blue/Orange should be connected??? or is it possible the wiring harness is wrong? I have never had this problem before.
AndyWarne:
You need to hook up the 4 directions and ground only.
One issue might be if the I-PAC and the U360 are powered from different sources and the I-PAC is being powered up after the U360. This might happen if the USB power for the U360 is supplied by PC standby power and the I-PAC is connected to PS/2 which might be powered from main power.
Andy
genesim:
Problem is solved..was a grounding issue. :cheers:
Twin-X:
--- Quote from: AndyWarne on May 31, 2009, 10:29:56 am ---You need to hook up the 4 directions and ground only.
One issue might be if the I-PAC and the U360 are powered from different sources and the I-PAC is being powered up after the U360. This might happen if the USB power for the U360 is supplied by PC standby power and the I-PAC is connected to PS/2 which might be powered from main power.
Andy
--- End quote ---
Hello Andy,
I do to seem to have this problem,
When i connect my voltmeter to the harnas connected to the ipac and make a close between ground and one of the 4 colors it does not switch. If i disconnect the ps/2 cable everything works.How can i solve this issue?
Jeffry
Pages: (1/1)