| Main > Main Forum |
| Swapping HAPP buttons for Sanwa Buttons |
| << < (2/4) > >> |
| Jack Burton:
I'm not sure that would work on 3/4" mdf |
| kowal:
it is for metal only, but you can taste. buy ver. which has 2 cutting edges maybe they are from three, do not buy from one cutting edges. |
| MrMojoZ:
--- Quote from: langdonx on May 28, 2009, 03:23:28 pm --- ETA: Maybe I'll just buy 6 Happ competition push buttons to see how similar they are to the OSBF 30's. --- End quote --- They feel nothing alike. |
| langdonx:
Nice... thanks for all the input. A fine-toothed round wood file sounds like my best bet. I think I'll try it on Player 2 side and see how it goes. Is there a better place to order Sanwa OBSF30 buttons from? LizardLick is only processing May 11th orders right now, so I'd probably have to wait 3-4 weeks if I did order them Monday. |
| jasonbar:
Or maybe use a half-round file, if you find one of a good size/curvature. Might make your work go faster, but it might also over-file if you're not careful... :dunno http://www.mcmaster.com/catalog/115/gfx/large/4218a16p1l.gif -Jason |
| Navigation |
| Message Index |
| Next page |
| Previous page |