Main > Main Forum
using a PSU to power LEDs...questions
BobA:
I thought you were using the switch to make the short to turn on the supply at the ATX connector. If that is where it is there is almost no power going thru it and a fuse is not needed. The other wiring should be OK as a good power supply is usually short and overload protected. Check the specs on your supply to make sure.
Fuses a good if properly sized as they can show where your problem is located in your wiring as opposed to just having the PS protect itself and turn off.
masterosok:
Forgive me, I know very little in regards to how these things work. I am just using the switch to turn the PSU on.
I just wanted to me be sure that nothing gets fired because I wiring something stupidly.
Thanks for the help.