Main > Main Forum
New Product: VersaBall2 Cross-compatible Joystick Upgrade Shafts -GroovyGameGear
<< < (2/7) > >>
mrclean:
will these fit u360's / work with them ? If so is it by any chance 3/4'' longer ?? I know andy sells one that's 10mm longer but mines mounted on mdf 3/4'' and they sit way too low.
Ginsu Victim:
mrclean:
No, they don't.
RandyT:

--- Quote from: kowal on May 20, 2009, 01:11:32 pm ---on SUZO this shaft still need original washer or new pivot? without this custom shafts they crunch,

--- End quote ---

The original plastic parts must still be used.  This makes the ball sit higher, but this is an advantage for these sticks when mounted below the panel.  A longer shaft increases the throw of this otherwise short throw stick.


--- Quote ---6 groove to what it serves?

--- End quote ---

It is an alternative shoulder stop.  If a user wishes for the shaft to sit higher, they can install the smaller, upper clip in this groove.


--- Quote from: butteroj on May 20, 2009, 10:17:09 pm ---Will the balltops be replaceable w/ sanwa/seimitsu balls?

--- End quote ---

No.  They use a 5/16 - 18 thread.

RandyT
Franco B:

--- Quote from: RandyT on May 21, 2009, 01:54:31 am ---
--- Quote from: butteroj on May 20, 2009, 10:17:09 pm ---Will the balltops be replaceable w/ sanwa/seimitsu balls?

--- End quote ---

No.  They use a 5/16 - 18 thread.

RandyT

--- End quote ---

Is that Whitworth or UNC or..?

Maybe you could make a M6 x1mm adpater for them so people can use the Jap balls, I imagine they would be more popular. Maybe you could offer them hollow too for LED lighting etc?
RandyT:

--- Quote from: Franco B on May 21, 2009, 02:13:38 am ---Is that Whitworth or UNC or..?

--- End quote ---

UNC


--- Quote ---Maybe you could make a M6 x1mm adpater for them so people can use the Jap balls, I imagine they would be more popular. Maybe you could offer them hollow too for LED lighting etc?

--- End quote ---

I didn't feel there was enough strength in aluminum to consider smaller diameter threads, and this would be exacerbated by a hollow shaft.  I suppose someone could make an adapter, but it would increase the length and probably look like dookie...

Navigation
Message Index
Next page
Previous page

Go to full version