Main > Main Forum
turbo twist 2 help
(1/3) > >>
clickhea:
my spinner has never worked since i got it, and i always figured it was because it wasnt hooked up correctly and decided to put it off till later.

well now its later, and iam trying to figure out whats wrong.

i have the master version with its own interface board.

the spinner is plugged into its board, and the board is plugged into my pc via usb.

i noticed there is a wire hanging off the harness with a 2 pin connecter, is this suppose to be connected to something on the turbo twist board? i cant find my directions.



as of right now, the spinner does nothing, even in windows.
leapinlew:

--- Quote from: clickhea on May 10, 2009, 06:02:08 pm ---my spinner has never worked since i got it, and i always figured it was because it wasnt hooked up correctly and decided to put it off till later.

well now its later, and iam trying to figure out whats wrong.

i have the master version with its own interface board.

the spinner is plugged into its board, and the board is plugged into my pc via usb.

i noticed there is a wire hanging off the harness with a 2 pin connecter, is this suppose to be connected to something on the turbo twist board? i cant find my directions.



as of right now, the spinner does nothing, even in windows.

--- End quote ---

Doesn't the 2 pin connector connect the board to the actual spinner?
leapinlew:
I just looked at mine.

There is a connection from the Turbotwist 2 spinner to the mainboard. 1 looks like power and the other is connected to the jumper pins on the board (for master if you only have 1).

Can you take a pic?
clickhea:




iam holding the connecter in my hand in the first pic.

dont mind the messy wiring it has to be cleaned up
leapinlew:
You connect that to the pins on the PCB for Master.
Navigation
Message Index
Next page

Go to full version