Main > Main Forum
maximus arcade + u360 + mapping
arzoo:
--- Quote from: Encryptor on September 28, 2009, 07:33:17 am ---
--- Quote from: Bender on April 24, 2009, 10:26:33 pm ---
run maximus and open preferences and go to the configuration tab and then the ledwiz tab (I know you don't have a LEDwiz)
check Run LEDBlinky, and use LedBlinky Configuration, you must do this under each emulator you want a Map to load in
then run one game from each emu, don't worry It won't work right just yet but you need to do it (trust me on this)
--- End quote ---
Bender or Arzoo,
I was trying to follow your instructions for configuring LEDBlinky to work with MA. I'm using MA ver 2.10.6 and ver 3.8 of LEDBlinky. The problem I ran into has to do with the quote above. I do the LEDBlinky Config part and save it but when I go into MA and go to the configuration tab I do not have an LEDWiz tab to click on. What am I doing wrong?
Encryptor
--- End quote ---
Hmm, if you don't see the LEDWiz tab below the Configure tab then something seems wrong with MA. You may need to post a message on the MA forum. Here's the screen shot of my MA preferences app using 2.10 -
Bender:
--- Quote from: Encryptor on September 28, 2009, 07:33:17 am ---
Bender or Arzoo,
I was trying to follow your instructions for configuring LEDBlinky to work with MA. I'm using MA ver 2.10.6 and ver 3.8 of LEDBlinky. The problem I ran into has to do with the quote above. I do the LEDBlinky Config part and save it but when I go into MA and go to the configuration tab I do not have an LEDWiz tab to click on. What am I doing wrong?
Encryptor
--- End quote ---
Also you are using MA 2.10.6 which is an early beta of MA.
Get the final version of MA 2.10 (which is actually newer than beta 2.10.11)
Encryptor:
Ok Thanks I'll try that.
Encryptor