| Main > Main Forum |
| maximus arcade + u360 + mapping |
| << < (5/5) |
| arzoo:
--- Quote from: Encryptor on September 28, 2009, 07:33:17 am --- --- Quote from: Bender on April 24, 2009, 10:26:33 pm --- run maximus and open preferences and go to the configuration tab and then the ledwiz tab (I know you don't have a LEDwiz) check Run LEDBlinky, and use LedBlinky Configuration, you must do this under each emulator you want a Map to load in then run one game from each emu, don't worry It won't work right just yet but you need to do it (trust me on this) --- End quote --- Bender or Arzoo, I was trying to follow your instructions for configuring LEDBlinky to work with MA. I'm using MA ver 2.10.6 and ver 3.8 of LEDBlinky. The problem I ran into has to do with the quote above. I do the LEDBlinky Config part and save it but when I go into MA and go to the configuration tab I do not have an LEDWiz tab to click on. What am I doing wrong? Encryptor --- End quote --- Hmm, if you don't see the LEDWiz tab below the Configure tab then something seems wrong with MA. You may need to post a message on the MA forum. Here's the screen shot of my MA preferences app using 2.10 - |
| Bender:
--- Quote from: Encryptor on September 28, 2009, 07:33:17 am --- Bender or Arzoo, I was trying to follow your instructions for configuring LEDBlinky to work with MA. I'm using MA ver 2.10.6 and ver 3.8 of LEDBlinky. The problem I ran into has to do with the quote above. I do the LEDBlinky Config part and save it but when I go into MA and go to the configuration tab I do not have an LEDWiz tab to click on. What am I doing wrong? Encryptor --- End quote --- Also you are using MA 2.10.6 which is an early beta of MA. Get the final version of MA 2.10 (which is actually newer than beta 2.10.11) |
| Encryptor:
Ok Thanks I'll try that. Encryptor |
| Navigation |
| Message Index |
| Previous page |