Main > Main Forum
CPO art for x arcade tank stick
(1/3) > >>
zaktallica:
So has anyone attempted to cover up the ugly x on the tank stick? I was going to order this http://www.mamemarquees.com/atomic-cpo-v2-p-164.html does anyone have the exact dimensions or a layout I can use to cut the holes? If anyone's put this over there tank stick do you have any suggestions?
zaktallica:
none?
enskpo:
I'd like to find out too.  I've covered all of the wording on mine with a permanent black marker, leaving only the "X" graphic.  It looks a lot better, matches perfectly, and only I can tell.  I do  have to renew it once in a while because it wears off. 
zaktallica:
ya I want to get that CPO cause my can is black and blue..,.
GeoMan:

--- Quote from: enskpo on April 16, 2009, 07:11:54 pm ---I'd like to find out too.  I've covered all of the wording on mine with a permanent black marker, leaving only the "X" graphic.  It looks a lot better, matches perfectly, and only I can tell.  I do  have to renew it once in a while because it wears off. 

--- End quote ---

A common solution is to use a sheet of plexiglass to avoid wear on your graphic. It requires some work as you have to cut the holes on the exact spots on it.

Navigation
Message Index
Next page

Go to full version