Arcade Collecting > Restorations & repair

Star Wars - fully working!

<< < (2/46) > >>

Spyridon:

--- Quote from: Level42 on March 27, 2009, 02:00:35 pm --- Crate the AD and ship to the well known adress ;) ;) ;)  :laugh2: :laugh2: :laugh2:

--- End quote ---

Okay, here you go

Spyridon:

--- Quote from: Level42 on March 27, 2009, 02:02:29 pm ---Hey, the WG6100 has the piggy-back over-voltage protection installed...nice.

--- End quote ---

It also has the LV2000 mod already done (thanks Frizz)

Level42:
You mean you haven't even shipped it yet ? Tsssssss !!!  :laugh2: :laugh2: :laugh2: :laugh2: :laugh2: :laugh2: :laugh2: :laugh2: :laugh2: :laugh2: :laugh2: :laugh2: :laugh2: :laugh2: :laugh2: :laugh2: :laugh2: :laugh2: :laugh2: :laugh2:



Looking again at the picture, that CRT connector is the "slide-on" type (compared to the pin/hole type) and they suck. I can't remember that the WG I worked on had it, but I probably forgot.
This connector kind is also used on Hantarex 900's, been working on those, and one is still "reasonably" connected, but the other.....a former owner tied some wire to the yoke and put some card-board behind it to keep it in place. (The 900 has a metal frame that allows that). Amazingly it actually works...
I would love to exchange the connectors and plastic part on the CRTs, but I bet finding those parts is pretty hard nowadays. A thrown-away TV could be your best bet.

Spyridon:
Yeah, replacing it could be tough.  I'm going to just try and get a good solid connection and "weld" it in place with silicone.  It worked fine for FrizzleFried before he shipped it, so if I just get it held in place I should be fine.

FrizzleFried:

--- Quote from: Level42 on March 27, 2009, 02:02:29 pm ---Hey, the WG6100 has the piggy-back over-voltage protection installed...nice.

--- End quote ---

...and a Spaeth LV6100 low voltage mod...

EDIT: er...already discussed.

Navigation

[0] Message Index

[#] Next page

[*] Previous page