Main > Main Forum
Need suggestions on how to deal with T-molding Problem
<< < (2/2)
cmoses:
I had a similar problem on my first cabinet.  Get some thin (width) masking tape and apply it to the T-Molding along the spline, folding it over so it is on both sides.  You may have to apply a couple of layers like this.  It basically builds up the thickness of the spline and allows it to grip when inserted into the groove. 
evitagen:
I had this problem with my Control Panel... for some reason I cut the slots a size too big.  Not really sure why, since I did the rest of the cabinet the correct size.  Anyway... hot glue works great.  And it's so very easy.
Hoagie_one:
I went with the hot glue.  Worked awesome.
Navigation
Message Index
Previous page

Go to full version