Main > Main Forum

Is bondo the only way to go?

Pages: << < (2/8) > >>

severdhed:

i'd say it depends on how big the holes are.  i used wood filler on my control panel to cover crew holes and fill in some small gaps, and it worked great.  i've tried using bondo in the past, but it is a pain in the
 

Todd H:

I used bondo on my cabinet and it couldn't have been easier. You just mix it, fill in the hole, let it dry, and sand. You can't even tell there was a hole there. heck, I rebuilt two bottom corners with it and it turned out beautifully.

AMDman13:

If I had to do it again I would have used Bondo.
Wood filler and putty seem to shrink and expand with climate changes.

mountain:

Bondo rules!

I leave a can of it open in my garage at all times, just to remind me how great it is  :dizzy:

Bender:

bondo is BYOAC's best friend!

unlike spacle and woodfiller which are mostly water based, so shrink when they dry. bondo is an epoxy type thing that cures cemically so no shrinking

I chaged a 2 hole set up to 3 hole layout, in no time, don't think I could have done that with anything else
plus it's ready to work in 30 min. just awesome.



Pages: << < (2/8) > >>

Go to full version