Main > Project Announcements
Glory Days - Completed!
dekar24k:
--- Quote from: Octo on March 31, 2009, 09:11:49 pm ---I would definitely consider getting another sticker to replace what's covered by the trackball plate. That are had some of the coolest looking art, but now it's a big, gray blob :embarassed:
--- End quote ---
What I could do, is order another copy of the CPO print from mamemarquees, and then cut out a square overlay for the trackball plate. I'm not sure how well the overlay will stick to the trackball plate though. I might figure something out, but I'm not sure I will do something about it right away. Thanks for the kind words btw.
sju4sju:
Hey dekar24k, I see you're from Norway; Me too..
How much was the shipping for the bartop kit? 'Cos the estimates on the mameroom site are like $2-300 for a 2-player control panel kit, which seems a tad high ::)
dekar24k:
--- Quote from: sju4sju on April 01, 2009, 10:56:47 am ---Hey dekar24k, I see you're from Norway; Me too..
How much was the shipping for the bartop kit? 'Cos the estimates on the mameroom site are like $2-300 for a 2-player control panel kit, which seems a tad high ::)
--- End quote ---
Hey man! :) Unfortunately the calculated shipping on Mameroom.com is correct. It's damn expensive to ship these kits from the US. I asked about shipping costs for a pre-assembled UAII cabinet as well and that would cost around $1,500 USD. :P
BASS!:
Btw they make a "zinc" plated tb plate that doesn't have the bumpy finish for like $1 less. Divemaster sells em. You can always recess that tb plate by borrowing someones router, then put the new graphic over everything. Doesnt matter if your not the best with tools as bondo will take care of all the fiddly bits.
dekar24k:
--- Quote from: uprightbass360 on April 02, 2009, 02:25:12 am ---Btw they make a "zinc" plated tb plate that doesn't have the bumpy finish for like $1 less. Divemaster sells em. You can always recess that tb plate by borrowing someones router, then put the new graphic over everything. Doesnt matter if your not the best with tools as bondo will take care of all the fiddly bits.
--- End quote ---
Thanks for the tip. I might look into it!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version