| Main > Main Forum |
| What are good tools to use.....? |
| (1/1) |
| studmuff:
What tools should I use to cut out a coin door hole? Finished plywood 3/4". I tried a jigsaw but I was bouncing off the plywood. I'm obviously not a handyman. Making a pin cab for vp and fp cab. Thanks. Tom. |
| BobA:
If your jigsaw is bouncing you may not have the proper blade in it or are not holding it down correctly. Make sure you have a good sharp wood cutting blade in it. Also it is a good idea to drill pilot holes at the corners to make it easier to start the cut. |
| studmuff:
Thanks bob I'll give it a try. Tom. |
| studmuff:
Jigsaw Worked good! I actually made a 3/4" circle with a drill to get me started. Thanks for the tip Bob. Tom. |
| Navigation |
| Message Index |