| Main > Main Forum |
| U360 hollow shaft and balltop. Where to buy? |
| << < (2/2) |
| AndyWarne:
We do sell longer shafts. But I would be interested in feedback from anyone using hollow shafts with this type of "fixed" LED wiring. I would be worried that the wires would become stretched and affect play if the handle is rotated, which it would be eventually, but maybe its not an issue. Andy |
| Derrick Renaud:
How about a U360H(ollow) manufactered with built-in stop pins so it does not turn much. Then sell an optional LED balltop; switch balltop or even better, LED/Switch balltop. |
| AndyWarne:
I think play would be affected if the stick were limiting against pins. The best method is a rotating contact eg jack, but not easy to do on this stick. Not impossible though as it has been done. |
| whammoed:
--- Quote from: AndyWarne on March 13, 2009, 11:12:04 am ---I think play would be affected if the stick were limiting against pins. The best method is a rotating contact eg jack, but not easy to do on this stick. Not impossible though as it has been done. --- End quote --- A slip ring would be ideal for this situation, however I doubt an off the shelf item exists that would work. This could leave the end of the shaft free to mount the magnet. |
| urbecrisch:
When I started the thread I was under the assumption that the LED works with the balltops & U360 hollow shafts. Can someone chime in who has actually produced this setup. I wasn't thinking about how the shaft would turn with the wires...good point. Andy, I could see you selling a lot of these if it was something you could produce. Any thoughts? |
| Navigation |
| Message Index |
| Previous page |