Main > Main Forum

Cannot calibrate wheel/pedal with California Speed/SF Rush

Pages: (1/3) > >>

mikeveli20:

When either California Speed or SF Rush is launched, I am told that I need to press the brake pedal to begin calibration. However, in the controls for the game, there is no place to input the control for the brake pedal, there is only 1 button and it represents the gas. I've been able to skip this calibration screen, but then I have no brake pedal in game. Anyone been able to solve this?

Turnarcades:

Try the mamedev's website to see if there are specific calibration instructions for these games, as some driving games do require a bit of a calibration workaround.

mikeveli20:

Thanks for the reply. I searched around the website and wasn't able to find anything that was helpful. Is there a specific section I should be looking in? Mostly everything I could find was general information and couldn't find anything related to how to calibrate a specific game.

u_rebelscum:

Looks like these are using player 2 pedal 1 for brake, instead of player 1 pedal 2 like it should.  Just map your brake to player 2's pedal.

mikeveli20:

Ok, so I was able to make it past the California Speed calibration by assigning the Brake Pedal to P2 Pedal 1. However, neither the gas nor the brake work in game. I press on them and nothing happens. P1 Pedal 1 is assigned to Joy 1 Accelerator and P2 Pedal 1 is assigned to Joy 1 Brake. I tried a various combination of reversing each pedal in the analog controls, but still no luck with that. Any ideas?

As far as SF Rush goes, I was able to assign the Brake the same way I did in California Speed, but I need to press the clutch pedal to advance past the calibration. I only have two pedals on my wheel, so therefore I'm unsure how I can get past this. And I'm assuming if/when I do, I'll run into the same problem above with the pedals not working in game.

Pages: (1/3) > >>

Go to full version