| Main > Main Forum |
| Wiring Coin Mech |
| << < (4/5) > >> |
| Vaad:
Can't really get any good shots of it wired ATM mate .. if you need some help send us a pm and i will see what i can do to help out. |
| Marky_1979:
Will do mate i think i will be having a go at wiring the cab in next few days |
| Vaad:
I changed my post above the wiring .. check it out will give you all the info you should need |
| Marky_1979:
--- Quote from: Vaad on January 29, 2009, 09:14:59 am ---This is Coin Mech end SW1 - No Wire SW2 - No Wire 0v - Black Wire .. This wire comes from the light bulb in the PCB board and back out again -- Wire this into the Earth of where the power is coming from.. i used the PSU P2 - Yellow with Black Banding Coin 2 on IPAC lamp - No Wire 12v - No Wire MET - White wire with Red Banding -- Ignore this 12v - No Wire P1 - Orange wire with Black Banding -- Wires to Coin 1 on IPAC 0v - Black -- This is the earth that needs to be wired into IPAC or what ever version you are using Key - No Wire 12v - Orange Wire -- Wire this into where you want to take your power from .. i used the PSU 12V cable --- End quote --- Does it matter if I use the ground from this on only on the second ground imput on the ipac or will i have to split the ground so it goes into both groyund slots on the ipac? as i already have a ground wire in there for all the other controls. Also having issues with the wires on my coin door as when i use the player 1 coin and orange and black wire and what should be ground the ipac gets very hot very quickly so i unplug it as there is something very wrong, have i forgot to do something? |
| Vaad:
I have IPAC mini and it only has one ground cable.. i just pushed the coin grounds into the Grey wire of IPAC and all was fine. |
| Navigation |
| Message Index |
| Next page |
| Previous page |