Artwork now available! X-Men 6 Player cab!

Arcade Collecting > Restorations & repair

<< < (18/61) > >>

warmeister:
Btw, DeLuSioNal, is there any way you(or anyone with a 6 player cab) could snap a few pics of the bottom of the cab? Preferably of the isolation transformers, ground straps, and where the straps connect. I had to take everything out and clean and paint the inside. It was pretty hacked up down there, too. I know where most of it goes, but not all of it. It would be nice to get it as close to original as possible. I'd appreciate it!!

DeLuSioNal29:
Thanks for the help warmeister. Still a ways for me to go but that helps tremendously.

Anyone else up for helping out with the vectorization? Colossus in particular is proving challenging, since he is very detailed. Any help would be great. Flip_Willie has been a great help and has vectorized, Dazzler, Storm and Wolverine so far. He should be starting Nightcrawler soon. I'm still working on Cyclops, but I'm an amateur at this so it is taking longer than expected.

The background (X-men logos) took a while, but it's now perfect, along with the 6 player instructions on either end. The huge yellow X-men logo is also done.

Once the characters are done, I'll need to work on the "Attack", "Mutant Power" and "Jump" stuff. I actually have them in high res, so I don't need to vectorize them. However, I'm not sure if I should include these on the CPO design itself, or if I should get them as separate stickers to be placed afterwards. I'm nervous about not lining them up properly if they are printed on the CPO. Thoughts?

And Warmmeister, your setup is probably better than mine. There are unconnected wires everywhere, as I bought it in a "non-working" state. Although I tested the board and it works (along with the monitors) everything is in shambles and I'll have to refer to the manual when I assemble it. I have the original manual if you need it. I can always scan it in.

Also, I have NO bezel at the moment. So I don't even have a reference for those graphics, AT ALL. Anyone?

edit: I meant to type in bezel, not marquee above.

~ DeLuSioNaL

Flip_Willie:

--- Quote from: DeLuSioNal29 on June 14, 2009, 09:50:51 pm ---
Anyone else up for helping out with the vectorization? Colossus in particular is proving challenging, since he is very detailed. Any help would be great. Flip_Willie has been a great help and has vectorized, Dazzler, Storm and Wolverine so far. He should be starting Nightcrawler soon. I'm still working on Cyclops, but I'm an amateur at this so it is taking longer than expected.

--- End quote ---

Sorry for disappearing, but I am still working on the project -- I have just been a little busier lately.

I have started working on NightCrawler. I have made decent progress, but it still needs more work.

EDIT: I'll go ahead and upload what I have so far of everything so that people can take a look. As far as I am concerned, all of it is still a work in progress. Specifically, Wolverine and Nightcrawler need work.

Flip_Willie

DeLuSioNal29:
Again, if anyone wishes to help with any of these PM me. Flip_Willie is holding his own though, and I am very thankful!

~ DeLuSioNaL

DeLuSioNal29:
By the way, for those that are interested. This X-Men arcade game is based on a pilot episode called "Pryde of the X-Men"

See it here:
http://forum.arcadecontrols.com/index.php?topic=93341.msg982117#msg982117

~ DeLuSioNaL

Navigation

 Message Index

Go to full version