Main > Main Forum

IPAC2 Problem, help!!

Pages: (1/4) > >>

ZEN:

Hey all, I have an Ipac2, running on a windows 2K.  I wired up the panel and it worked the first time through, after reboot, I cannot get the keyboard to work, keyboard flashes lights on boot but then is dead.  When plugged in by itself it works fine.  The funny part is when after boot, the mouse works, but the minute i touch/depress a button on the keyboard or the cnt panel, the mouse freezes too.  I cant figure this out, I have searched here and ultimarcs board, no avail.  Anyhelp would be great, I have checked all connections, grounds, etc, and they all seem fine.  The ipac lights up at boot and stays solid as well, anyhow, thanks in advance. :banghead:

ZEN:

sorry, not sure why this posted 3 times....

slasherman:

sounds like a driver problem...try to uninstall the HID keyboard (all) then reinstall..I'm not sure if the windows 2000 needs spesial driver. Did it have a installation with it ? If so be sure you use the right driver..


or maybe you should change to tiny xp...

AndyWarne:

Two questions which are a first step to troubleshooting:

Are you running in USB or PS/2 mode and what happens on the self-test LED at power up?

Andy

ZEN:

This is ps/2.  The light is solid upon start-up.  This is the same on 3 diff pcs, albeit diff o/s.  I am on w2K.  It remains solid the entire time.  Mouse works , but as soon as I depress any key or button from CP, neithr work.  If I unplug the IPAC and run just the keyboard, it works fine, both mouse and keyboard.

Thanks Andy for the response.  I appreciate it...

Pages: (1/4) > >>

Go to full version