Main > Project Announcements
Project : C-MACC'S 2 - (update - Subzero Cooling Phase change -50 c)
mayhem:
Thks Gatsu any one can steal my idears lol .....
Bad wood working skills test fiiting the TS to a CP. Its a little tight but it goes lol ..
Had to lose the warrenty though :) .... Speaker has been remove and the back pannel has gone to boot as well. Ive sticky taped the back PCB to the back of the screen to hold it into place. that babys is going no ware fast i can tell you.
This is not the final (could be though) but more over giveing me idears how to fit it.
mayhem:
Well a few more updates.
I've been working in the crazy British weather. One min it dry and lovely next is pissing down with rain and boy does that annoy some one whose just spent a few hours spay painting. Any way on with the show as such ...
To start off with I Painted the top Sliding draw for the PC to fit on and then after a few days of it hardening in the airing cupboard i proceed to use T-Cut and polish on the wood to get a smooth deep shine.
After a few about 20 min of letting the polish filtrate i then give it a good rub down with a cloth.
As you would expect it has a nice deep fish to it.
Next I proceed with the Touch screen Cp and sanded it down and then undercoated it a few times. Pics of it in different stages below.
The low and behold it started to rain ... arrrrrr...
After drying it down and waiting for the rain to stop i then did a quick sand down with 1200 grit wet and dry and then spayed plastic coating over the top.
The once that is dry you supposed to wait 24 hours lol ... did i hell. I then started to paint it.
mayhem:
This is the vairous stages of layering paint on the lcd CP ...
Then off to dry in the airing cuboard
mayhem:
Another load of build pics for you to looks at. First we have the LCD mock yp set up and then its been layered with varnish. There is how ever still some damage to the system due to the lovely British weather but that's just life. im sure once my kids get their hands on it it would be worse ...
mayhem:
Then i fixed the LCD section to the base CP and then re sprayed it a few more times ..
Once that was all dry i then polished it down. you'll notice some damaged due to the weather but that is just life and since there i need to put a graphics and also a plastic over the top its not to much of a problem.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version