Main > Project Announcements
Project : C-MACC'S 2 - (update - Subzero Cooling Phase change -50 c)
mayhem:
I Love the buttons to be honest they have a nice strong feel to them and they feel rigid with a good strong click when depressed. They feel like many of the arcade systems of days gone by, i felt a few years back when i was a kid. I know and fully understand these are not to every ones taste but ill back them up all the way. I have 14 of these buttons , 6 for each player and 2 x player buttons on my C-Macc's 1 and they have been in there nearly 9 months plus now and they have been hammered and work perfectly.
I have had the happ buttons but again i think its each to there own and i feel as thous are to soft and don't give the rigid feel that i would like on my buttons.
Yes i might be using Cold Cathode in the base of the system with die in the water cooling loops if and when i get round to fitting it all. Im not going to go to over board though as i think to much lighting kills the system looks. There are to many systems that are over lighted and its like "the only gay in the village" shouting out in the street atop his voice making sure every ones know that HE IS the only gay in the village while wearing a Velcro florescent tank top in pink and yellow just to prove it !!!!!!!. :o hehe.
here are some Pics of the Buttons in my old C-Macc's
mayhem:
Some more shots of the Cp Being made . As you can see its changed lol ...
parag0n:
Is that GPS so you can get from one side of it to another? :laugh2:
Seriously, awesome work, cant wait to see how it ends up :)
mayhem:
yeh the Gps is there for Till i get the touchscreen. Its the same size i need for the Cp hence im using it to give me a idea of were ill be putting the touch screen. If there was a way of interfacing it i would use the GPS but sadly there isnt lol ...
mayhem:
well last night i had a big cock up. I accedentley pulled off the wires to a £60 spintrak. Oh my did i cause some damage. This wasn't in any way the fault of the Spintrack but move over my fault for messing around with the CP and getting it caught of the frame work and while pulling it away ....
Lucky i figured out the pin outs and after a small amount of doing some retrace work and track repair and some soldering its now working again.
Next time ill be a little more careful ...
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version