| Main > Main Forum |
| Is primer nessesary? |
| (1/2) > >> |
| _JMFR:
After many hours, i FINNALY finished sanding down and smoothing out a cab i'm building. i was debating if i should prime it before i rolled the paint on. Any advice? * I realize i should maybe move this to the woodworking section.....but the Main board gets the most action! :laugh: |
| Blanka:
1 prime layer and 2-3 final layers. Light sanding after every layer, except the last off course. If it is MDF/Particle board, clean the surface first with Aceton :dizzy: Final layer paint naked wearing undies and a hairnet, between some wet bedsheets (to prevent dust). Water paint should be painted horizontal, alkyd paint is best done vertical. |
| _JMFR:
--- Quote from: Blanka on January 12, 2009, 03:29:05 am ---1 prime layer and 2-3 final layers. Light sanding after every layer, except the last off course. If it is MDF/Particle board, clean the surface first with Aceton :dizzy: --- End quote --- Whats a good primer to use?? |
| Blanka:
Same solution as the final paint, so both water based or both non water based. Sigma Satin U2 is very good stuff. |
| _JMFR:
where can this sigma satin be found? |
| Navigation |
| Message Index |
| Next page |