Main > Project Announcements
XBOX 360 Street Fighter Stick #2
Malenko:
--- Quote from: somunny on January 10, 2009, 09:51:37 pm ---
--- Quote from: Malenko on January 10, 2009, 09:35:40 pm ---can I get the plans for that? I cut the wood for a stick and it looks like crap compared to that
--- End quote ---
I didn't really use any plans but I'd be happy to draw up the dimensions for you.
Also, is it me or does the wood look all wavy in the second and third pics? Must be the shadows.
--- End quote ---
that would be awesome. If you could send me the artwork file too, to use as a template, I'd appreciate that too
EDIT:Removed email addy
somunny:
Got the pieces trimmed today and glued the corner blocks to the front and back panels. I also routed out the lexan. Unfortunately, something got underneath the router and scratched the Lexan through the protective film. Total loss on that.
dmworking247:
Nice sticks, they certainly seem more repeatable (less complicated joins etc) than my own.
Have you routed T-molding grooves in the side walls, and the CP top?
Is that plexi over the artwork? Did you have any trouble shaping the plexi and the artwork to the CP surface (ie rounding the corners, etc)?
Gatsu:
looks really good man. What are you gonna use to put the bottom box together?
I got all the pieces cut out for my next 2 sticks. Just gotta get the laminate.....no luck finding a local distributor though. I asked everyone I could at Lowes and Home Depot...and no one seemed even slightly interested in helping me find what I needed. So I talked to a couple of managers (one in each store) and told them I didn't care to shop there if no one was willing to help.
So...gonna have to order it online somewhere.
somunny:
--- Quote from: dmworking247 on January 11, 2009, 07:31:38 pm ---
Have you routed T-molding grooves in the side walls, and the CP top?
Is that plexi over the artwork? Did you have any trouble shaping the plexi and the artwork to the CP surface (ie rounding the corners, etc)?
--- End quote ---
Thanks, dm. These are pretty much your basic-square-box-controllers. Yep, all the t-molding routing is finished. I use the cp as a template to route the Lexan out so it is the exact same shape (for better or worse!). Once I adhere the cpo to the cp, I trim off the excess and it's all done.
--- Quote from: Gatsu on January 11, 2009, 11:04:25 pm ---looks really good man. What are you gonna use to put the bottom box together?
So...gonna have to order it online somewhere.
--- End quote ---
I assemble the sides using glue only and then screw the cp and the bottom cover on. No clear bottom for me. This thing is big and there still doesn't seem to be enough room for a fancy wiring job.
Man, I can't believe it's so hard to get laminate out your way. Hopefully you'll find a hook-up.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version