| Main > Main Forum |
| Spray Painting. I need some help! |
| (1/3) > >> |
| Justin:
I painted the front of my cab today, black. I'm basically painting over what seems to be black (old) laminate, from an original Centipede cab. Anyhow, I tried my best to follow tips from this forum, and spray painted in 2 passes, shaking can constantly, etc. The results I got are nothing short of horrendous! I see shiny blotches and dark blotches all over the place. it is not at all uniform across the surface... especially noticeable when light reflects off it -- and this is a semi-gloss paint I used, so light does reflect... What can I do now about this? Spray paint over it oncce more? Any tips on how to do this right? it is not a big area really... just the bottom of the cab, where the coin door is. Oh, I'm using Rustoleoum Black Semi Gloss. The same I used for the coin door. I'll post a pic in a while. |
| Apollo:
Painting over laminate. Step 1 180 grit sand paper Step 2 Prime the surface. You have 2 problems, paint doesn't like to stick to laminate and you are using an oil based paint. You need to get the right primer or it just won't work. See a professional. Step 3 220 grit sand paper ( lightly ) Step 4 Prime again Step 5 220 grit sand paper ( very lightly ) Step 6 Spray paint, wait 24 hours Step 7 Spray paint again. Step 8 Sit back and say "Damn that's a good finish" Well I never said it was quick |
| steve_pss:
i can say the only good results i've gotten from using spray paint on here went like this: 1.make a few passes as you did already to allow the wood to soak up and prime (not really relevent over laminate i guess) 2. With the piece lying flat and level to prevent runs spray the heck out it, making sure you lay it on enough to create an even, generous (i mean generous) coating. Help to have i light source off to the side to make sure its a nice even looking heavy coat. 3. be patient with the drying process, ya just laid it on thicker then recommended it will take a bit longer to set up. Following this process seems contrary to the nice light multiple coat process that seems logical but you will burn through MANY cans of paint going that route; at least I did before I lost my patience and stumbled (bumbled) on this method. My cab looks very good. Nice and shiny (see your selfself in the reflection) black laquer. |
| Justin:
Well I must say that at least the 2 coats of spray paint are stuck there... so whether this was laminate or not, it painted just fine. I will try Steve's method, and spray paint the hell out of it tomorrow with a thick coat. If that don't work, then I can always resort to shooting myself. :P |
| madk:
The only way I could make anything I spray painted good was to scrap the spray paint and get a good roller. :) I rolled on almost all the paint on my cab and it looked amazing. No brush strokes or anything. |
| Navigation |
| Message Index |
| Next page |