Main > Main Forum
Dropped my Turbotwist 2 - Help!
drawfull:
Oops, I dropped my TT2 and the black part that the PCB plugs into has come away from the spindle in that it can move slightly up and down. So when I spin, the bit with the PCB connector spins and (possibly) tangles the wire
Is there a way to fix this or do I need to buy a new one?
edited for clarity
RandyT:
You need to send it back to be repaired. Don't spin it in this state! It could damage it further.
As long as the internals are still ok, the only cost will be actual shipping fees.
RandyT
Games001:
Randy T.. always the gods amongst men when it comes to helping out the buyer. A+
CheffoJeffo:
I dunno about the god part, but definitely a very cool thing to do.
:applaud:
whammoed:
I take it some sort of epoxy is used to hold it together? Just curious. I was looking over the two I purchased and don't see an obvious way to disassemble them. I have to resist the urge to take things apart sometimes to avoid destroying them. 8)