Main > Main Forum
Dynamo "cut-corner" CP modifications
Todd H:
I ended up modifying my Dynamo cut corner to take a bigger control panel. I had to cut notches out the build a shelf for the panel to sit on. Knievel did the same with his Neon MAME project. If you decide to go that route message either him or me and we can probably help you out with the measurements.
Jack Burton:
I don't think you need to put a seventh button in place unless you are used to the Neo-Geo layout. Otherwise, use
BCD
A
or my preference
AC
BD
johnnybleu:
Thanks for all the replies! That's what's great about a place like this- the sharing of ideas. ;)
Anyway, for the time being I think I'll stick with just 6 buttons. Maybe some day down the road, I'll make a bigger CP to replace the standard one, with all the buttons I want/need. That being said, I really want to get this thing going as soon as possible, so if I can save some time by using the factory CP, then great- also, I wasn't exactly looking forward to drilling through that metal plate. O_o
Once (and if) everything is up and running, then I'll sit down and think about further modifications and customizations.
Thanks again!