| Main > Main Forum |
| How do I install a SpinTrak? |
| (1/1) |
| Chris2:
I've been scouring Ultimarc and the BYOAC wiki, but I haven't found anything about how I would install the spinner. I have a 3/8" - 7/16" hole on my panel, and I don't know how I could make the spinner stay in place with such a hole. Also, how do you fit the spinner head on top? I try using the screws from the flywheel, but they go right through the holes. |
| blind_dado:
The SpinTrak fits into a standard 1-1/8" hole. The spinner top should have two set screws in it that tightens against the shaft. There are some pictures here that might help: http://forum.arcadecontrols.com/index.php?topic=83463.msg871860#msg871860 |
| Navigation |
| Message Index |