| Main > Main Forum |
| How would you mount the OSCAR USB Interface? |
| << < (2/3) > >> |
| Tiger-Heli:
--- Quote from: _Iz- on June 21, 2003, 02:20:54 pm ---Cut an anti-static bag into a large "band-aid", fold that around the pcb leaving extra on each side, tape it closed and then staple thru the extra on each side to secure. --- End quote --- Double sided foam tape is always an option, but I like _Iz-'s idea better. |
| tom61:
--- Quote from: _Iz- on June 21, 2003, 02:20:54 pm ---Cut an anti-static bag into a large "band-aid", fold that around the pcb leaving extra on each side, tape it closed and then staple thru the extra on each side to secure. --- End quote --- Anti-static bags are conductive, not a good thing to wrap around a live electronic device! Anti-static bags are for only storing electronics. |
| jakejake28:
electric tape |
| Mike:
Mounted mine by putting a plastic washer on a screw and putting one on each side. |
| OSCAR:
Hmm, lots of creative ideas here! :) I put a screw on either side of it and looped a nylon zip tie around them. This makes it easy to remove if you need to, just pull the zip off one of the screws and the board comes out. |
| Navigation |
| Message Index |
| Next page |
| Previous page |