Main > Main Forum
Ultimarc U360 slop anyone else?
(1/3) > >>
gatordad:
I had some slop on one of my U360's so I replaced the springs with the stiff ones.
Slop is still there, what causes this?
The other stick is nice and tight when it returns to center but one of them has slop ( slight movement ) when in the center position, any ideas?
Love the sticks but this is frustrating.
Ginsu Victim:
There's a tiny bit of wiggle room at center, but nothing that has ever caused any issues for me. If it creates any problems, you could always increase your dead zone.
gatordad:
I disassembled it and just below the pivotball there is a thin washer.
Mine is bent slightly in a convex type of fashion.
Are these supposed to be straight or slightly bent?
Anyone who has one handy could check I would appreciate it.
Franco B:
It should definitely should be straight. I'm not sure how you managed to bend yours as there should be no forces acting upon the washer to bend it. Are you sure you have reassembled it correctly?
Todd H:
Got one of mine in today and installed the stiff spring, longer handle, and circular restrictor. Mine has zero slop and is nice and tight.

And the washer definitely shouldn't be bent.
Navigation
Message Index
Next page

Go to full version