| Main > Main Forum |
| What size hole to drill for buttons, joysticks? |
| (1/2) > >> |
| dkubarek:
I got the X-arcade BYOAC buttons, sticks and board and can't find what size holes to drill. The buttons look like they would fit very snugly in a 1 1/8 inch hole. However, it could be a 1 1/4 inch hole. I'm also unsure of what size hole to drill for the joystick. Anyone know? |
| CheffoJeffo:
http://wiki.arcadecontrols.com/wiki/Control_panel_hole_sizes |
| fixedpigs:
http://forum.arcadecontrols.com/index.php?topic=71031.0 |
| dkubarek:
Ok, and I'm guess the x-arcade buttons match the Happs standard buttons and the joystick is the same as the ultrastick. Both 1 1/8 inch, right? Thanks |
| somunny:
I've gotten the best results with a spade bit and they can usually be had for less than either a forstner or a hole saw. More importantly, be sure to clamp some scrap to the back/under side of whatever it is you're drilling or you're liable to make a mess coming out the other side. |
| Navigation |
| Message Index |
| Next page |