Main > Main Forum
LED Wiz wiring questions (help randyt or anybody;))
<< < (5/8) > >>
Bonechip:


Anode = Long wire (Positive side)
Cathode = Short wire (Negative side)
Bonechip:


Another example
blind_dado:
So the resistor can go on either the anode or the cathode.  Well, wish I knew that when I was wiring up my cp, because practical concerns made it a PITA to put the resistors on one rather than the other.  Learn something new every day!
RandyT:

--- Quote from: blind_dado on March 02, 2009, 06:08:58 pm ---So the resistor can go on either the anode or the cathode.  Well, wish I knew that when I was wiring up my cp, because practical concerns made it a PITA to put the resistors on one rather than the other.  Learn something new every day!

--- End quote ---

Resistors resist current flow.  Putting them on either side of the circuit will work.


RandyT
Tony555:
Hi all.

I just have a quick question about wiring up to the NEW LEDWiz. I will need to use power from my PSU in the computer.

Do I wire it the same as the diagrams above??? I have re-done the diagram below to represent the new LED Wiz. Is this the correct way of wiring (my new writing is in purple)...why does the NEW LEDWiz call it USB+5v??? Why not just +5v???

Navigation
Message Index
Next page
Previous page

Go to full version