Installed the coin door wire harness onto the coin door. Nothing was labled on the connections so I had to go pull out the pin out to determine what goes where (the loose wires are for the lock out coils which weren't present on this coin door)
While I was in there, I replaced the two coin door bulbs with new ones.
Then installed the marquee, coin door and control panel onto the cab.
I picked up a NOS back door sheet a while ago, but I never unpacked it until today. Looks really nice. Nice bright white and in great shape.
Installed on the back door:
I also assembled the Arcadeshop reproduction bezel. It came shipped in two pieces
It connects together by an ahesive on two of the tabs. Just pull off the paper and stick it together
First side done
Second side done:
Just setting it in place to see what it looks like. Need to figure out which end is the top? I won't staple it in place until the monitor is back in.
Can anyone tell me if Centipede used smooth or textured t-molding?