| Main > Main Forum |
| Messy holes |
| (1/3) > >> |
| Dexter:
Hi all, My first attempt at drilling through plastic on my net city cab has been a bit of a disaster. I need something to fit between the happ competition buttons and the plastic panel itself to hide the sloppy cuts (i.e. holes are slightly oval and you can see a gap when button is fitted.) Any suggestions? I normally drill wood and get it spot on. Dexter |
| somunny:
Dremel out the hole in a joystick washer? |
| SirPeale:
Not possible to start over? Did you clamp the plexi down when you drilled? |
| Franco B:
Could make you some button bezels. Any width/diameter/bore etc. |
| Visitor Q:
^^^ Those look nice. |
| Navigation |
| Message Index |
| Next page |