Hi!
Ive got a few problems with an old, almost fixed MTC900 monitor.
The previous owner connected the powercable to the brightness/contrast header and blew out the following parts:
The TDA3501, 7812, and a few diodes.
After replacing the parts and adding a cap kit the monitor works again, or that will say almost works, the problem is, that the picture is very dark, even with brightness/contrast and G2 turned all the way up.
Im not sure where the fault could be, even with G2 on full power i get no retrace lines, the picture is still dark.
Any ideas ?
Regards
DarkSide