Main > Main Forum

Mag Stik Plus Assembly Picture

Pages: (1/2) > >>

Epyx:

I was carefully (well trying) to take apart the Mag Stik Plus but the force of the spring pushed the parts out before I could see the order...anyone have a picture of the order for re-assembly? I have two washers with teeth that I am the most concerned about (with regards to order).

Thanks in advance...

paulscade:

When I tool mine apart... I placed the parts on the table in order... hope this helps...

http://forum.arcadecontrols.com/index.php?topic=82241.msg891255#msg891255

I believe that the toothed washers were on the inside of the u shaped part.

Epyx:

Awesome. Thanks very much!

AndyWarne:

There is a full diagram on http://www.ultimarc.com/controldiags.html if you still need any info.
Andy

opt2not:

Hey Andy, do you sell the Mag Stik Plus replacement shafts alone?  Without balltops?

I've got a few spare balltops I want to use, but I don't want to go through the hassle of trying to breakthrough the locktite seal of the balltop shafts you supply off your site.

Thanks!

Pages: (1/2) > >>

Go to full version