Main > Main Forum
Mag Stik Plus Assembly Picture
(1/2) > >>
Epyx:
I was carefully (well trying) to take apart the Mag Stik Plus but the force of the spring pushed the parts out before I could see the order...anyone have a picture of the order for re-assembly? I have two washers with teeth that I am the most concerned about (with regards to order).

Thanks in advance...
paulscade:
When I tool mine apart... I placed the parts on the table in order... hope this helps...

http://forum.arcadecontrols.com/index.php?topic=82241.msg891255#msg891255

I believe that the toothed washers were on the inside of the u shaped part.
Epyx:
Awesome. Thanks very much!
AndyWarne:
There is a full diagram on http://www.ultimarc.com/controldiags.html if you still need any info.
Andy
opt2not:
Hey Andy, do you sell the Mag Stik Plus replacement shafts alone?  Without balltops?

I've got a few spare balltops I want to use, but I don't want to go through the hassle of trying to breakthrough the locktite seal of the balltop shafts you supply off your site.

Thanks!
Navigation
Message Index
Next page

Go to full version