Main > Main Forum

Fluorescent Light Power Draw

Pages: (1/2) > >>

Necro:

Ok, so i know watts = volts x amps and all that, but I'm having some trouble figuring out the power draw of my fluorescent lights in my cab when first turned on.  They have a 15W bulb, so I can easily figure out the amps once running but the FS-2 starter I can't seem to find information on.

Can anyone provide any help?  I want to make sure I don't use underrated equipment.

(Also, the ballast says 35A on it...I'm assuming that means it will handle up to that, correct, and not that it DRAWS 35A which is a bit insane...)

Necro:

Damn...no one?

drawfull:

Since most lighting circuits are 5A that should be plenty.

Inrush current should not be an issue at all, *I* wouldn't worry about the inrush current... what are you switching it with?



Necro:

That's actually what I'm trying to decide on - I want to make sure I don't have too much current running through the switches I buy.  It's going to most likely be a 20A switch that will have the light, a computer, and a monitor on it.  I highly doubt it would be an issue since normal switches are 24A I believe, but the 35A thing on the ballast threw me off.

SirPeale:

You'll be fine.  That's just how much the ballast can handle.

Pages: (1/2) > >>

Go to full version