Main > Main Forum

T-Molding Alternative

Pages: << < (2/3) > >>

beerbarrel:

http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=93371


Seems OK..

Tracy



beerbarrel:

I went to Harbor freight last night and picked up the slot cutter set. It seems like a good set for light use. It costs 26.95 for the set of 6 bits w/arbor but you can normally print out a 20% off coupon from their website.

Tracy



--- Quote from: beerbarrel on November 28, 2008, 09:03:57 pm ---http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=93371


Seems OK..

Tracy



--- End quote ---


Sardu:


--- Quote from: beerbarrel on December 07, 2008, 10:18:39 am ---I went to Harbor freight last night and picked up the slot cutter set. It seems like a good set for light use. It costs 26.95 for the set of 6 bits w/arbor but you can normally print out a 20% off coupon from their website.

Tracy



--- Quote from: beerbarrel on November 28, 2008, 09:03:57 pm ---http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=93371


Seems OK..

Tracy



--- End quote ---

--- End quote ---

Thanks Tracy

web.geek:

Probably too late for the OP, but I will add this for the benefit of future visitors. In my first cab, I skipped the t-molding in favor of using my router with a 1/4" (or maybe 1/8") rounding bit. This gave the 5/8" MDF a nice rounded edge and eliminated any sharp corners. Then I just painted it the same color as the sides. Not as flashy as t-molding, but effective.

Having said that, I am going to use t-molding on my second cab  ;D

LLUncoolJ:

I also routed the edges on my jukebox. It is really easy with mdf.

I just completed a new control panel for my MAME cabinet. I stood the board on its edge and ran a 1/8" groove down it with a table saw. I filled the groove with liquid nail and applied the t-molding. I just did the first side last night and clamped it, I'll update later to how it works. :burgerking:

Pages: << < (2/3) > >>

Go to full version