| Main > Main Forum |
| New GGG Product: Tron Joystick Handle - was: Soooo.....what's this thing worth? |
| << < (5/39) > >> |
| Ummon:
So this is the repro unit he's been hinting at. |
| RayB:
Just the 2 shells? $40 tops. (says the guy who paid $100 for a small plexiglass repro control panel!) ;D |
| Havok:
I'd say $30. And yes, make a Star Wars yoke and the circle will be complete. |
| CheffoJeffo:
IIRC, Specialty Plastics was selling them most recently for $60 shipped, but their website has once again vanished (this time due to AOL closing down the hosting service). |
| Necro:
I would say cost of manufacture plus 40% margin plus shipping. Unless that comes out to be insanely expensive...or cheap. Then again...I'm in the biotech industry. :) What my suggestion would be to have the handle alone plus accessories. Have the custom accessories (i.e. a joystick ready to have the handle attached) at a higher margin than the handle. ...ok...I think maybe I'm getting into this too much. :) |
| Navigation |
| Message Index |
| Next page |
| Previous page |